The CPU hotplug works similar to the memory ballooning: one has to specify a maximum number of virtual CPUs available (and this can't be changed at runtime) and a number of currently added CPUs.

In the XML, the vcpu element has to be updated to the following:

<syntaxhighlight='xml'>

 <vcpu placement='static' current='N'>M</vcpu>

</syntaxhighlight>

where N is the currently enabled number of CPUs and M is the maximum number of CPUs.

The following only works if the Qemu Guest Agent is running inside the guest. If that is not the case, one may still add a CPU but Linux will not take it online automatically and removal of CPUs is not possible (since libvirt can't be sure that the guest has taken the CPU offline prior to removal).

<syntaxhighlight='bash'>

1. Set the number of vCPUs to 2 = adding one CPU if the VM was started with N=2, M=2

virsh setvcpus --live --guest 375e8f9c-8bc7-4bb3-8d9b-fdfe448ce0c2 2

1. Record the change in the XML (--config and --guest are mutually exclusive options)

virsh setvcpus --config 375e8f9c-8bc7-4bb3-8d9b-fdfe448ce0c2 2 </syntaxhighlight>

This leads to the following output within the VM:

[  236.693907] CPU 1 got hotplugged[  283.406919] SMP alternatives: switching to SMP code[  283.418566] smpboot: Booting Node 0 Processor 1 APIC 0x1[    0.020000] kvm-clock: cpu 1, msr 0:3ff97041, secondary cpu clock[  283.430008] TSC synchronization [CPU#0 -> CPU#1]:[  283.430008] Measured 570321522131 cycles TSC warp between CPUs, turning off TSC clock.[  283.430008] tsc: Marking TSC unstable due to check_tsc_sync_source failed[  283.445610] KVM setup async PF for cpu 1[  283.445618] kvm-stealtime: cpu 1, msr 3fd0cb80[  283.445664] Will online and init hotplugged CPU: 1

If there is no guest agent, you will see only the first line.

<syntaxhighlight='bash'>

1. Set the number of vCPUs to 1 = removing one CPU if the VM was running with N=2, M=2

virsh setvcpus --live --guest 375e8f9c-8bc7-4bb3-8d9b-fdfe448ce0c2 1

1. Record the change in the XML (--config and --guest are mutually exclusive options)

virsh setvcpus --config 375e8f9c-8bc7-4bb3-8d9b-fdfe448ce0c2 1 </syntaxhighlight>

This leads to the following output within the VM:

[  352.153088] Unregister pv shared memory for cpu 1[  352.260054] smpboot: CPU 1 is now offline

Maximum CPUs can't be changed at runtime

The VM must be started with the maximum set higher than 1 to be able to hot-add CPUs.

Removing CPUs may possibly lead to SMP task scheduler on UP system

When adding CPUs Linux automatically switches to a SMP-aware task scheduler. When reducing the number of CPUs to 1, there is no kernel log entry saying that it switches to a UP scheduler. So it is possibly still using a SMP scheduler on a now UP system.