Difference between revisions of "Manually adding a new bridge"
From stoney cloud
| [unchecked revision] | [unchecked revision] |
(Created page with "= Overview = The following page describes the steps to manually add a new bridge (<code>vmbrX</code>) to an existing stoney cloud installation. = Prerequisites = To be able t...") |
(→Prerequisites) |
||
| Line 6: | Line 6: | ||
* VLAN ID, such as <code>141</code> | * VLAN ID, such as <code>141</code> | ||
* IP prefix, such as <code>192.0.2.0/24</code> | * IP prefix, such as <code>192.0.2.0/24</code> | ||
| + | * Default gateway address (if any), such as <code>192.0.2.1</code> | ||
| + | * Broadcast address, such as <code>192.0.2.255</code> | ||
Make sure, that you have configured your additional VLAN on all the involved switches and routers beforehand. | Make sure, that you have configured your additional VLAN on all the involved switches and routers beforehand. | ||
Revision as of 11:27, 6 February 2014
Contents
Overview
The following page describes the steps to manually add a new bridge (vmbrX) to an existing stoney cloud installation.
Prerequisites
To be able to add and configure a new bridge, you need to have the following informations present:
- VLAN ID, such as
141 - IP prefix, such as
192.0.2.0/24 - Default gateway address (if any), such as
192.0.2.1 - Broadcast address, such as
192.0.2.255
Make sure, that you have configured your additional VLAN on all the involved switches and routers beforehand.
